Broken connectorĦ1-2 Control mast function is partially restricted Connector cable is damagedĭrive control function is limited (MFD opt) Load sensor is faulty Broken connectorĦ1-1 Load sensor abnormal Rear wheel swing control is limited. Broken connectorĥ4-1 Swing lock solenoid abnormal Rear wheel swing control is limited. Steer knob is not in position Speed sensor is brokenĥ2-1 Yaw rate sensor abnormal Rear wheel swing control is limited. Each error code and the time at which it occurred are displayed alternately at 2Ĥ1-1 Matching connector abnormal Only the Connector display is faultyĥ1-1 Speed sensor abnormal Speed indicator keeps showing 0 km/h Connector is faultyĥ1-2 Rear wheel swing control Damaged connector cable and error code are displayed each time the knob switch is pressed and released. For how to display the main menu, refer to (1) From the main menu, display the diagnosis memory menu. Here the display method using the hour meter and tilt lever is described. Diagnosis memory display method To display the diagnosis memory display, there are a method using the hour meter and tilt lever, a method using the optional display, and a method using a When this happens, stop the vehicle immediately and check the error code.Ģ.
Travelling or performing meterials handling operations, an error code is displayed and the lamps turn on as a warning. With the ignition key switch ON, if an abnormality is detected when the vehicle is stopped,
The lamp lights once to allow checking for the bulb, and then turns off again if the status is normal. When the ignition key switch is turned ON, Diagnosis display method The diagnosis is displayed by means of an error code as shown in the illustration to the left, and by the lights turning on.
0 kommentar(er)
